Rubber sheathed cable equipment manufacturers tell you that rubber sheathed cable is a flexible movable cable made of multiple strands of thin copper wire as conductor, covered with rubber insulation and rubber sheath. Generally speaking, it includes general-purpose rubber flexible cables, welding machine cables, submersible motor cables, radio equipment cables, and photographic light source cables.

Rubber sheathed cables are widely used in various electrical equipment, such as household appliances, motors, electrical equipment and mobile power cords for appliances. At the same time, it can be used indoors or outdoors. According to the size of the mechanical external force, the cable can be divided into light, medium and heavy three categories. There are also appropriate connections in the cross section.

Rubber cable equipment manufacturers tell you that the general light rubber cable for household appliances and small electrical equipment, soft, light, good bending performance.

Medium-sized rubber cable in addition to industrial use, widely used in agricultural electrification;

Heavy-duty cables are used in port machinery, searchlights, and large-scale water conservancy and irrigation stations in domestic industries. This kind of product has good versatility, complete series specifications, good performance and stability.

Rubber cable equipment manufacturers for your popular science rubber cable application range

Waterproof cables and cables for submersible pumps: mainly used for supporting submersible motors, with JHS and JHSB models.

Cables for radio equipment: At present, two kinds of rubber-sheathed cables (one shielded and one unshielded) are mainly produced, which can basically meet the requirements. The models are WYHD and WYHDP.

Photographic cable products: With the development of new light sources, its structure is small and its performance is good, which meets the needs of indoor and outdoor work, and gradually replaces some old products with heavy weight and poor heat resistance.

Rubber cable equipment manufacturers tell you the matters needing attention for your popular science rubber cable

1. equipment: automatic temperature control, timing, multi-specification tubular cavity of small pressure equipment.

2. rubber: Consistent with the steel wire of the repaired steel wire, the rubber content is higher than the repaired material, and the curing system is slightly stronger.

3. rubber cable equipment manufacturers for your popular science rubber cable operation method:

1. Set the temperature and time according to the vulcanization system of the rubber.

2. Clean the repair parts with rubber ink thinner, especially the joint parts should be fully treated.

3. Cut the repair glue according to the size of the gap, be careful not to have too much or too little.

4. Plug the cut rubber material in the gap, and pay attention to the rubber material not higher than the circumferential surface of the wire.

5. wrapped with high temperature resistant PP tape. And put it into a tubular mold cavity slightly smaller than the diameter of the wire, and lock the upper and lower molds to make the filling position have a certain pressure. Note that the mold cavity diameter is slightly smaller than the wire diameter by 0.1 to 0.2mm..

6. When the vulcanization time is over, remove the product. If a small amount of rubber spills, repair with a sharp blade and sand with thinner.

4. rubber sheathed cable equipment manufacturers for your popular science verification method:

Press a proper amount of air into the power line and place it in the water. If there is air leakage, the quality can be judged.