Rubber cable equipment is a kind of general cable, its material is natural rubber, the development trend of the middle and late gradually transformed into the present synthetic products, in which the natural is a series of closely combined compounds, called synthetic rubber, other compounds can also be used to make synthetic, its performance is better than natural. In addition, other vulcanized materials also have different physical and chemical properties, and vulcanized rubber suitable for various products can be made with various ingredients.

What are the advantages of the widely used rubber cable equipment? The following is an introduction.

1. other uses must be other cable products. As we all know, the application of its products is suitable for all industries, these industries and all areas of people's daily life. Depending on the scene, the products used are also different. For example, the cable used in the project is a particularly small class in its family, and there are also many special cables for major purposes, especially those that are not clear. Unique products must have special properties such as acid and alkali resistance, low temperature resistance, wear resistance, radiation resistance, heat resistance, etc. This performance requires the application of acorn line.

The technical progress of 2. machinery and equipment has provided convenience for the rubber sheathed cable. The production of acorn cable must first be made of glue, which is generally called acorn production and processing. Through the wrong material, filter, storage and other processes, the acorn production equipment is huge, complex and energy consuming. With the development of science and technology, machinery and equipment are constantly innovating. The new machinery and equipment in the new era has brought convenience to its production and processing, which is convenient for the development of products with different structures to meet different needs.

What are the reasons for the appearance defects of the rubber-sheathed cable equipment? The following is an introduction.

1. The load-bearing line of the mold sleeve is too long or too short, the mold is not smooth, the aperture is too large, and the temperature of the head, chip port or main body is low, which may cause the surface to be not smooth.

2. Its supply is not clean, contains impurities, coke burning time is too short, extrusion colloid, head or mold temperature is too high, it does not flow smoothly in the head, its material stays in dead corners, not smooth screws, adhesives, etc. may cause clinker particles (early vulcanized rubber particles) or impurities on its surface.

3. The mold cover is not smooth, there is no chamfer, or foreign cooked plastic particles block the entrance of the mold, the traction tube in the yellowing tube is scratched, and the rubber pad at the exit of the vulcanizing tube is smaller in diameter, so its surface may be There are scratches and scratches.

4. The aperture of the mold set is too large. The gap between the outer strand of the conductive core and the single chamber is too large, the outer diameter of the cable core is uneven, the rubber is small, the viscosity is poor, there are impurities in the acorn, and its surface may collapse due to the small mold distance and pressure.

5. The aperture of the die set is too small. Insufficient rubber extrusion, insufficient core gap filling, conductive core or cable core jumper, when the mold distance is short, the surface may appear hemp.